Avtech AVH306 Manual do Utilizador descarregar pdf (Página 8)

CONNECTION

2. CONNECTION

2.1 Hard disk installation

The product appearance may vary from the picture shown below for different models; here take the 6CH model for

example:

Step1: Remove the top cover.

Step2: Find the hard disk bracket in the NVR, and place the compatible hark disk in the bracket.

Step3: With the PCB side facing up, connect the hard disk to the power connector and data connector.

Step4: Fasten the hark disk with the supplied screws, two for each side.

Step5: To install another hard disk, find the supplied hard disk brackets in the package, and fix them onto the NVR

base.

Step6: With the PCB side facing up, connect the hard disk to the power connector and data connector.

Step7: Then, put the hard disk in the bracket, and fasten it with the supplied screws, two for each side.

Step8: Replace the top cover and fasten the screws you loosened in Step1.

Note: Before remote firmware update, please install a HDD into your NVR first to make sure the

firmware update works properly.

Note: It’s not recommended to use a green HDD with your NVR to make sure it works properly.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 137 138

Sem comentários

Avtech AVH306 Manual do Utilizador Página 8